White strobe fuel help needed

[Sanman]

Hi I recently am making some strobe fuel but everywhere I look even the videos don't really answer the questions that I have. And it's mainly to do with the ammonium perchlorate and potassium dichromate. The ammonium perchlorine I got is 200 mesh, am I supposed to grind that down to a fine powder? And with the potassium dichromate it comes granular like sand am I supposed to grind that down to a fine powder as well? The rest of the chemicals I have are very fine powdered. I'm using the 60/ 25/15/5 typical white strobe recipe. Thing is when I do grind them down my strobe doesn't look anything at all like the ones I see online. Instead of gray powder with a slight yellow tinge, mine is a lot more yellow from the dichromate. Hopefully someone could point me in the right direction tell me what I'm doing wrong or is that what it's supposed to look like.

[displayfireworks1]

Give it some time with this post. I hope you get a response to this question. We have a few members that have experience making fireworks that check in from time to time.

[Sanman]

Thank you I hope so too, I'll be keeping an eye out.

[chris v]

Yes you should mill your comp but it sounds like you have an excess of PD, the usual formula is as follows
60 AP
21 Mg/al 200 mesh
9 Mg/al 325 mesh
15 Barium sulfate
5 PD
+3 vasoline
Hopefully this will help

[Sanman]

It does help thank you!!!