Mississippipyro
05-08-2020, 03:45 PM
http://www.pyrotalk.com/bulletin/attachment.php?attachmentid=4871&stc=1
On this board I have four cues. All of the cues will not be fired back to back they are spread out across the show. Should I be concerned about one setting the others off? I was considering using aluminum foil over each set to ensure this doesn?t happen, is this a good idea? It would also serve to protect any fuse or sticky match being used. My later boards I?ve gotten away from most if the fusing I?m matching just about everything, for example if I?m firing four cakes I?m using igniters that will be wired together so four in parallel. If I have, say 4 200g cakes going of at three positions I have the four at each position fused using sticky match and the three positions running in series.
On this board I have four cues. All of the cues will not be fired back to back they are spread out across the show. Should I be concerned about one setting the others off? I was considering using aluminum foil over each set to ensure this doesn?t happen, is this a good idea? It would also serve to protect any fuse or sticky match being used. My later boards I?ve gotten away from most if the fusing I?m matching just about everything, for example if I?m firing four cakes I?m using igniters that will be wired together so four in parallel. If I have, say 4 200g cakes going of at three positions I have the four at each position fused using sticky match and the three positions running in series.