Replacement spring clips for firing modules

[PyroKing31]

Not sure if this is the right subforum for this.

I have a bilusocn 1200 china system. I had a show this weekend and had one of the spring clips that holds the e-match leads in break. the red clip and the small spring is gone.

Based on photos it looks like the cobra and everybody uses the same clip design.

Where can I buy replacement clips and springs?

Thanks!

[AxeElf]

When you can just buy a whole new module for about $10, it may not be worth the time and effort of trying to replace one spring and clip.

[PyroKing31]

It should be very cheap parts, but I may have to go that direction, although I have not found where to buy just bare modules. They are always in kits

[Robbro097]

Id just replace mods but if u really wanna try n repair id guess its these just basic speaker terminalshttp://www.pyrotalk.com/bulletin/attachment.php?attachmentid=4333&stc=1

[PyroKing31]

Id just replace mods but if u really wanna try n repair id guess its these just basic speaker terminals4333

Good find, Ill have to open it up and see the internals. Thanks!

[Robbro097]

If you go this route update if it works and how difficult some1 else may find it useful in the future

[Zippster]

Had to do this once on my subwoofer, kids broke the springs. The unsoldering was a pain in the neck. Chinese system, I would probably just buy another of the ebay 3 module kits and be done with that broken module.

[morrison2951]

Yep, for the $25-30 cost af a Chinese 3 module kit shipped, I vote for the new ones as well.

[PyroJoeNEPA]

The problem tou will run into is there about 5 or 6 different configurations for the 2 spring clip speaker terminals...red on right, red on left, PC board solder mount, solder tab mount, size, etc.....Buy another module and keep that one for spare parts. Also, sometimes Eric at pyroboom has some "not working--for parts" ones for sale very cheap.